| 1. | The main stress in ` photography ' falls on the antepenultimate syllable
Photography一字的主重音在倒数第三个音节上 |
| 2. | ( 3 ) in main stress trace protraction , based on the character of main stress trace , propose an automatic method
( 3 )研究了一种简便快速的主应力迹线自动化绘制方法。 |
| 3. | Most of the subjects are reported to have low rather than high stress , and the main stresses the college staff faced are chronic but acute stressor
大学教师的工作压力强度总体看不高， 84 %报告工作压力不大，另外16 %报告工作压力大。 |
| 4. | In addition , the main stress at the interface of the bottom flange and inclined web , which located at the interface with the diaphragm , is the largest . so , it should be taken more attention to them in design
另外，横隔梁与斜腹板及底板交界处的底板及斜腹板区域，其主应力数值最大，设计中应给予重视。 |
| 5. | Study was made by means of information distribution method on the fuzzy recognition of the relationship between the greatest main stress in practically measured ground stresses and the surrounding rock properties . the calculation results show that this method is feasible and has good recognition effect
用信息分配法进行了实测地应力中最大主应力与围岩关系的模糊识别研究，计算结果表明该方法是可行的，具有良好的识别效果。 |
| 6. | 3 . under different kinds of wall rock and the same condition , from ii iii v kinds of wall rock , and conditions of construction period and operation period , it gradually increases that the maximum of displacement and the first main stress third main stress of pipe liner structure
3 、不同种类围岩在相同的工况下，从、 、类围岩看，不论是施工期还是运行期，管片衬砌结构的位移的最大值和第一主应力、第三主应力最大值都逐渐增大。 |
| 7. | The study sets up 3 - d definite element models in terms of the seismotectonics of danjiangkou reservoir area . the models use drucker - prager yielded criterion to stimulate material property , which consider the influences of average stress and the second main stress on material strength
本文则根据丹江口库区的地质构造建立了三维有限元模型，采用drucker - prager屈服准则模拟岩石特性，即考虑了静水压力对材料屈服强度的影响，又考虑了中间主应力的影响。 |
| 8. | The result show , most of the medium - strong earthquakes faults are dip - slip reversed , distribution of the main stress p axis is sector from west to east ; there are large difference between kuche and baicheng region in seismic activities , but the characteristic of cluster is same in the two region ; the distribution of medium - strong earthquakes is nw direction in baicheng region , it show , there can have a concealed fault ; small earthquake clusters ' activities can reflect the effect that local medium - strong earthquakes to the secondary small structure around it
结果表明：南天山东段中强震震源断错以倾滑逆断为主，主压应力p轴由西到东呈扇形分布；相距较近的库车与拜城地区地震活动存在较大差异，但均存在明显的成丛性分布特点；拜城地区中强地震分布呈北西向可能预示著该区存在隐伏断裂，小震群活动则可能反映了局部中强震对周围次级小构造的影响。 |
| 9. | The stress analysis and the fatigue life loss calculation of steam drum are carried out in this article . a simplification formula is proponed to calculate the main stress and is used in configuration of dcs . the rain - flow method is used to count the fatigue cycle , which can satisfy the need of on - line monitoring
本文对其进行了应力分析和疲劳寿命损耗的计算，并提出主应力计算的简化公式用于dcs组态，采用雨流法作为在线计算的疲劳计数方法，满足了寿命损耗在线监测的要求。 |
| 10. | The results indicate the stress of copper interconnects generates in the metallization and the thermal stress caused by thermal mismatch during the damascene process is the main stress . the thermal stress distribution in copper interconnects has been simulated by the finite element analysis software with the different trench structures
对测量结果的分析得出金属薄膜的淀积是造成铜互连线中应力的主要原因，热应力在铜互连线应力中占较大比例，热处理后铜互连线中应力减小。 |
